3DPrinting

145 readers

1 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

founded 1 year ago

MODERATORS

jonmardyla@lemmy.world

j4k3@lemmy.world

Filament Dryers (lemmy.world)

submitted 1 year ago by EvilEwok@lemmy.world to c/3dprinting@lemmy.world

14 comments fedilink hide all child comments

So tried out some PETG for the first time, and the first couple prints went really well. but I believe it's picked up quite a bit of moisture, sitting in the basement.

What's the current recommendation for a filament dryer? there was one on /r/3dprintingdeals a bit back, a Sunlu S2. is the S1 good enough, or should someone who's fairly recreational with everything spring for a S2? I see food dehydrators recommended sometimes, is there anything specific to look for in one?

you are viewing a single comment's thread
view the rest of the comments

[–] cstine@lemmy.uncomfortable.business 3 points 1 year ago

That, and if your filament has anything toxic that can off-gas when you heat it, you probably don't want it in your oven (if you use your oven for cooking food).

I'm not sure which filaments are or are not going to have any additives that might be problematic, but since almost nobody actually says what's in their filaments, it's probably a good idea to just assume it's all not good for you and keep it away from your oven.