Do It Yourself

7763 readers

3 users here now

Make it, Fix it, Renovate it, Rehabilitate it - as long as you’ve done some part of it yourself, share!

Especially for gardening related or specific do-it-yourself projects, see also the Nature and Gardening community. For more creative-minded projects, see also the Creative community.

This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.

founded 2 years ago

MODERATORS

Gaywallet

alyaza

circularfish

Replacing cooktop. is a 2cm difference in cutout a big deal? (self.diy)

submitted 1 week ago by sanzky to c/diy

4 comments fedilink hide all child comments

Hello!

I plan to replace an electric vitroceramic cooktop for an induction one. Both are 60cm in width, but looking at their manuals, the current one specifies a cutout of 58cm while the new one says 56cm. Both specify the same height (49cm)

Now, thankfully I dont need to make the hole larger, but Im wondering if the extra 2cm will be a problem or not? The cooktop should cover the entire hole but Im not sure if it the extra space could allow it to move around. I'm hoping it would be ok (they tend to have an anti-slippery silicon thingy), but I prefer to ask if some has experience just in case.

you are viewing a single comment's thread
view the rest of the comments

[–] sanzky 1 points 1 week ago (1 children)

do you think glue would be enough? the top is granite so probably I cannot use screws

[–] Ashelyn@lemmy.blahaj.zone 4 points 1 week ago (1 children)

You might not even need them, it's more just an option if the unit wiggles around too much for your liking after dropping it in.

Definitely don't use screws or nails! Glue should be fine but you might need a method to hold them in place while it dries. Masking tape would probably do the job just fine; in fact, you could probably skip the glue and just tape the blocks into the gap from underneath the countertop. The latter case would definitely require careful inspection of the cooktop to make sure you're not covering up anything important.

The idea with the blocks/shims isn't to hold up the cooktop structurally, just to keep it from sliding side to side (and only if you need them, it might be perfectly fine without). The weight should still be primarily on the granite itself in all cases.

[–] sanzky 1 points 1 week ago

thanks for the input! I think you're right