this post was submitted on 27 Nov 2024
18 points (100.0% liked)

Science

13038 readers
1 users here now

Studies, research findings, and interesting tidbits from the ever-expanding scientific world.

Subcommunities on Beehaw:


Be sure to also check out these other Fediverse science communities:


This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.

founded 2 years ago
MODERATORS
 

When digging a pit, one way to prevent the walls from collapsing inward under pressure is to make them less steep, so they slant outward like the sides of a cone. A good rule of thumb is to make the hole three times wider than its depth.

[...]

Suppose you were to try digging through the Earth, and that the planet was all solid. (We know that it’s not, but this is the simplest scenario.) The depth of a hole all the way through the planet would be equivalent to Earth’s diameter, which is just a name for a line that passes straight through the center of a circle. So your hole would need to be about three times as wide as the diameter of the Earth in order for it to be stable.

Clearly, this is an impossible task that would completely alter the planet’s shape.

[...]

you are viewing a single comment's thread
view the rest of the comments
[–] Hamartiogonic@sopuli.xyz 15 points 1 week ago

That’s roughly how open pit mining works. In some mines, you start with a pit, but later make a mine shaft if you need to go even deeper.

A pit is relatively cheap to start with, but it becomes more expensive as you go deeper. Eventually, a traditional mine shaft becomes cheaper than continuing with a pit.

If you have a ridiculously deep mine shaft, you begin to run into various problems like walls collapsing and the temperature increasing. There can also be lots of water you need to pump out constantly.

Eventually, the shaft becomes so deep and the problem so large, that continuing becomes a nightmare. That’s why even the deepest mines aren’t really that deep considering how thick the tectonic plates are.