this post was submitted on 12 Sep 2023
6 points (100.0% liked)

Functional 3D Printing

71 readers
1 users here now

Welcome fellow prototypers! This communities' purpose is to help others and share functional 3D Printing related information. While other 3D Printing Communities are a good resource, sometimes too many help posts get buried under memes and fluff. This will remain technically focused and keep the fluff removed. Please help your fellow 3D Printer hobbyists as much as you can with their issues! and showcase your functional prints and how you use or created them.

founded 1 year ago
6
Dremel/Parkside Multi Grinder Holder by erevan12 (www.thingiverse.com)
submitted 1 year ago by ShadowRam@kbin.social to c/functionalprint@kbin.social
0 comments fedilink hide all child comments
 

This is an upgrade for the "Parkside Multi Grinder Holder" by rechena. Please also check the source creator. The changes are the following: The lower rear part has been reduced in height. The front part has been reduced in height, different for Parkside and Dremel. These changes were made to ensure the horizontality of the tool. Centering nuts were added, because the front support hole is wider. (3/4x12 for Dremel and 18x1.5 for Parkside) Screws have also been added to keep the original nuts when not in use. It is recommended that the nuts and screws be printed with the wider side down and at the finest resolution to ensure thread quality. Note: Fits Dremel 4000 and Parkside PFBS 160 C3

no comments (yet)
sorted by: hot top controversial new old
there doesn't seem to be anything here