A place to share our love of all things with two wheels and pedals. This is an inclusive, non-judgemental community. All types of cyclists are accepted here; whether you're a commuter, a roadie, a MTB enthusiast, a fixie freak, a crusty xbiking hoarder, in the middle of an epic across-the-world bicycle tour, or any other type of cyclist!
Community Rules
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia.
Be respectful. Everyone should feel welcome here.
No porn.
No ads / spamming.
Ride bikes
Other cycling-related communities
Long story short: completely stripper the hex slot on the back of the freehub body while trying to remove it. It’s incredibly tight. Can I just take a pipe wrench to it from the front or do the teeth seen here on the new part lock with the wheel hub making it impossible to turn?
Beats me, but I'd love to see the answer.
🎱 Outlook not so good. 🎱
If that freehub is constructed like the ones I've taken apart before, you're out of luck. Like you suspected, the teeth lock the rotation of the freehub to the hub, unless the screw in the back is taken out first.
You can try hammering in a (slightly larger) torx key or using an easy-out (probably won't work if it's very tight).
As a last resort, you could try to drill out the screw (only so far that the freehub comes off, you don't want to drill into the hub). Then you should hopefully be left with enough left of screw to grab with a pipe wrench.
Yeah I think I'm just going to disassemble the new one and move all the parts onto the old freehub body. There's no way I'm getting this one off without messing up the wheel hub. If correct size allen key and a 2 meter long cheater bar didn't get it to budge I don't think the torx method or a screw extractor is going to work either.