3D Printing

242 readers

1 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 4 years ago

MODERATORS

3dnudel@lemmy.ml

Why does filament not stick to the glass? (midwest.social)

submitted 10 months ago by BingoBangoBongo@midwest.social to c/3dprinting@lemmy.ml

19 comments fedilink hide all child comments

You can see where around corners and even some straight runs it is peeling up. I'm running first layer at an agonizing 15 mm/s. Using hatchbox pla filament, just dried in dehydrator. 200° nozzle and 70° bed. The glass is freshly cleaned with soap and water, I just did several atomic pulls, I've trammed at different heights using a feeler gauge, and absolutely nothing is working. Any one have any ideas?

you are viewing a single comment's thread
view the rest of the comments

[–] danieljoeblack 2 points 10 months ago (2 children)

I was having trouble with my glass bed originally, to get it working nicely without glue or hairspray I:

made sure the bed was very clean, I use rubbing alcohol to clean it
dialed in my z offset, I usually match it to my layer height, so if I'm printing at 0.2mm that's what I set the z offset to
upped my print temp a bit, I usually print at 205-210 with PLA

Maybe one of those will help?

[–] 20inmyhead@lemmy.ml 2 points 10 months ago (1 children)

+1 for upping the temp. I always find printing the first couple layers at 5° hotter to helps a lot with adhesion.

[–] BingoBangoBongo@midwest.social 2 points 10 months ago

Increase in temp seemed to help!