this post was submitted on 06 Oct 2024
594 points (100.0% liked)
Memes
1357 readers
8 users here now
Rules:
- Be civil and nice.
- Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It was all pretty straight forward. The kit was made to be assembled with a bolt on neck all predrilled, so it was basically just shaping the body and headstock and then paint and varnish.
I did look up some painting techniques, but I really just wanted to stain the wood, so I did that with a brush and then 2 coats of varnish. I had to sand the wood first to make it more open for staining instead of paint. If you want to paint or spray paint you should probably keep or make a base coat to avoid the wood absorbing the paint.
It was a cheap stratocaster-like kit, so I wasn't too concerned with making mistakes, but I'll admit that putting the saw into a guitar was a little daunting at first.
I used a multi-cutter for most of it to make very precise cuts. And lots and lots of sandpaper by hand with different grit sizes.
It only took a few evenings to do, so it is not difficult at all, but I guess it depends on how much you want to customize it.
Do you know the brand? Sounds like my next winter project.
I want to make one with normal pickups - Out1 and add a piezo bridge with a three way switch for an Out2. Some of the sounds people are getting by blending the two are incredible.
The kit I used was a Harley Benton from Thomann.
Awesome. Thank you.
No problem. Have fun.
I don't know if there's a community for this, but anyway, this is my "surf guitar".:
It's been a few years but it still looks like the day I made it.
That looks amazing. Thank you for sharing.